8
Task flow
To build a wireless LAN environment, you must configure both the
Access Point and the Wireless LAN PC Card.
Required tasks depend on the state of your Access Point and Wireless
LAN PC Card. The table below lists their states and tasks required for
building a wireless LAN environment.
*1 Refer to the operating instructions of the Access Point.
*2 See “Inserting the Wireless LAN PC Card” (page 14) and following sections in
this manual.
*3 See “To establish communication with the Access Point” (page 56) and
succeeding sections in this manual. For further information, see the Wireless
Palette Help files.
*4 Refer to the operating instructions of the Access Point.
1. Connect the Access
Point.
2. Insert the Wireless
LAN PC Card into a
computer, set up the
Windows-based
environment and
install software. (*2)
3. Register the Access
Point using the
Wireless Palette. (*3)
4. Configure the Access
Point. (*4)
1. Insert the Wireless
LAN PC Card into a
computer, set up the
Windows-based
environment and
install software. (*2)
2. Register the Access
Point using the
Wireless Palette. (*3)
1. Connect the Access
Point. (*1)
2. Register the Access
Point using the
Wireless Palette. (*3)
3. Configure the Access
Point. (*4)
• To communicate with
an Access Point
previously used in
another wireless LAN
environment from a
computer containing
the Wireless LAN PC
Card.
1. Register the Access
Point using the
Wireless Palette. (*3)
Access
Point
New
In use
Wireless LAN PC Card
New
In use
Summary of Contents for NBS-CN110
Page 151: ......
Page 152: ...Printed in Japan ...
