12
NW-E503/E505/E507
SECTION 4
DIAGRAMS
Note on Schematic Diagram:
• All capacitors are in
µ
F unless otherwise noted. (p: pF) 50 WV
or less are not indicated except for electrolytics and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise speci-
fied.
•
%
: indicates tolerance.
•
C
: panel designation.
•
: B+ Line.
• Voltages and waveforms are dc with respect to ground under
no-signal (detuned) conditions.
no mark : PLAY
*
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production toler-
ances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production toler-
ances.
• Circled numbers refer to waveforms.
• Signal path.
E
: PLAY BACK
a
: DIGITAL OUT
k
: DIGITAL IN
d
: TUNER
F
: AUDIO
Note on Printed Wiring Board
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side A)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side B)
the parts face are indicated.
• MAIN board is multi-layer printed board.
However, the patterns of intermediate-layer have not been in-
cluded in the diagram.
*
Replacement of IC400 on MAIN board requires a special
tool.
• Lead Layouts
surface
CSP (Chip Size Package)
Lead layout of conventional IC
•
Waveforms
Summary of Contents for NW-E505 - Network Walkman
Page 31: ...31 NW E503 E505 E507 MEMO ...
