5-10. Carry Loader Assembly
Preparation
1.
Remove the upper plate assembly. (Refer to
)
2.
Remove the bottom plate. (Refer to
3.
Remove the rear plate assembly. (Refer to
)
Procedure
1.
Disconnect the flexible flat cable from the connector (CN43) on the SM-44 board.
2.
Remove the two screws (M2 x 2.7) and the two screws (PSW2 x 5) to detach the carry loader assembly in the
direction of the arrow.
Note
Place the removed carry loader assembly with its bottom facing upward.
Carry loader assembly
SM-44 board
CN43
Flexible flat cable
PSW2 x 5
M2 x 2.7
M2 x 2.7
Bosses
Holes
Plate
The same applies to the other side.
Groove
Groove
Note
When installing the carry loader assembly, note the following.
• Match the grooves with the plate.
• Match the two bosses with the two holes.
3.
Install the removed parts by reversing the steps of removal.
ODS-D77U/ODS-D77F
5-17
Summary of Contents for ODS-D77F
