5-11. Carry Motor
Preparation
1.
Remove the upper plate assembly (Refer to
)
2.
Remove the bottom plate. (Refer to
3.
Remove the rear plate assembly. (Refer to
)
4.
Remove the carry loader assembly. (Refer to
Procedure
1.
Remove the tension coil spring.
2.
Remove the two screws to detach the motor holder assembly.
PSW2 x 5
Tension coil spring
Motor holder assembly
3.
Disconnect the harness from the connector on the SM-44 board.
4.
Release the harness from the two clamps.
ODS-D77U/ODS-D77F
5-18
Summary of Contents for ODS-D77F
