6(E)
Setting Up the CCD Unit
5
Connect the two flat cables from the cable adaptor
to the relay board using both hands.
6
Reattach the side panel of the camera head and
secure it with the four screws.
7
Connect the camera lens cable of the adaptor to the
LENS connector on the camera head. Tie down
the cable with the cable clamp.
8
Attach the supplied filter position label to the right
side panel of the camera head.
Attaching the Optical Head to a
Tripod Adaptor
Attach the optical head to the frame of a tripod
adaptor, and secure the head with the four screws.
S
Power HAD
S
Relay board
24-pin flat cable
20-pin flat cable
Blue strip
Cable clamp
Filter position
label
to the LENS
connector
OPT HEAD
CAM LENS
To connect the flat cable to the relay board
1
Lift up the connector clamp.
2
Insert the cable with the blue
strip upward until the strip is
covered.
3
Push down the clamp to the
original position to secure
the cable.
CAM HEAD
CAM LENS