30
Turning the System On/Off
• After the power is turned on, the camera moves automatically for trial operation. Be
careful not to catch your finger.
• If you use force to prevent the camera moving, it may not resume moving and not
output a signal to the Communication Terminal. In this case, turn off the Terminal,
and turn it on again.
• When you turn on the power of the Communication Terminal for the first time after
installation, the setup wizard will appear after the self-diagnosis is completed. Set up
your system following the wizard.
For setups using the wizard, see “Setting Up the System for the First Time
— Initial Setup Wizard” on page 34.
• Used with an optional device especially designed for use with this system, such as the
Data Solution Box or ISDN Unit, for the first time, the Communication Terminal may
automatically upgrade the software of the connected device. While the upgrading
message is displayed on the monitor screen, be sure not to turn off the Communication
Terminal. Doing so may cause malfunction of the system. System malfunction may
also occur when a system power-off has been caused by an accidental problem such
as a power interruption during upgrading. If connection of the Data Solution Box or
ISDN Unit to the Communication Terminal is not re-established even after the system
power is recovered, consult a Sony dealer.
To save power the Communication Terminal will enter standby mode if you
do not operate it for a specified period of time.
When the Communication Terminal is in standby mode, the POWER indicator
lights in orange. Once the Communication Terminal receives a call, the
standby mode is automatically released.
To release the standby mode
Press the
@
/
1
button on the Remote Commander.
To specify the standby time
Specify the time that you want the system to remain on before entering into
standby mode (1 to 99 minutes) using “Standby Time” in the General Setup
menu. If you do not want the system to enter the standby mode, set “Standby
Mode” in the General Setup menu to “Off”.
For the “Standby Time” and “Standby Mode” settings, see “General Setup
Menu” on page 49.
• The POWER indicator on the camera goes off when the system enters standby mode.
• If you use a Sony TV monitor with the IR repeater installed under the remote sensor,
the TV monitor will enter standby mode together with the Communication Terminal.
Notes
Standby Mode Function
Notes
Summary of Contents for PCS-1 - Video Conferencing Kit
Page 284: ...Sony Corporation ...