78
Setting Up the Network Configurations
The setting has been configured properly if the correct NAT address appears in
the launcher menu.
To display the NAT address in the launcher menu, you must set “Number
Display” to “NAT: Address” under page 4/4 of the General Setup menu (page
48).
3
Remote parties must configure under Page 1/11 of the LAN Setup menu in
the same way.
Remote parties do not need to configure the NAT settings in the LAN Setup menu
as they are not in a NAT environment.
To conduct a videoconference
Select “IP” under “Line I/F”, enter the remote party’s IP address, and dial.
When using the terminal in the NAT environment, you can connect to a remote party
(global IP), but for a remote party to connect to you, you must configure your router
settings. For details on router settings, consult with the system administrator.
When using PPPoE, you can connect via LAN without a router.
A modem (using bridge mode) is required when using FLET’S ADSL.
Configuration example
Note
Note
LAN (PPPoE Connections)
LAN Setup
LAN Mode
Auto Negotiation
Page: 4/11
On
210.10.10.1
On
NAT Mode
NAT Address
Packet Resend Request
Adaptive Rate Control
Save
Cancel
On
ON LINE
POWER
LAN ALERT
210.10.10.10
211.10.10.10
ON LINE
POWER
LAN ALERT
Local IP
network
B FLET’S
ONU
Internet
ONU
B FLET’S
Summary of Contents for PCS-1 - Video Conferencing Kit
Page 284: ...Sony Corporation ...
