96
Receiving a Call from a Remote Party
1
Press the CONNECT/DISCONNECT (
/
) button on the Remote
Commander.
The message “Disconnect?” appears on the monitor screen.
2
Press the
B
or
b
button on the Remote Commander to select “OK”, then
press the PUSH ENTER button, or press the CONNECT/DISCONNECT
(
/
) button on the Remote Commander again.
The system is disconnected.
The power of the Communication Terminal remains on even if the system is
disconnected.
To cancel disconnection of the system
Select “Cancel” with the
B
or
b
button, then press the PUSH ENTER button.
Or press the RETURN button on the Remote Commander.
To register the connected remote party in the Phone Book
You can easily register the remote party who has just disconnected.
If you set “Last Number Registration” in the General Setup menu to “On”, the
message “Register this participant in the list?” appears after a conference with
an unregistered remote party is finished. When you select “OK”, the Edit List
menu appears.
If the “Last Number Registration” is set to “Off”, the message does not appear.
For “Last Number Registration” setting, see “Last Number Registration” on
page 49.
Ending the Conference
Note
Note
Summary of Contents for PCS-1 - Video Conferencing Kit
Page 284: ...Sony Corporation ...
