Chapter 2
Basic Operation During a Meeting
71
Chapter 2
Tip
You can also clear the still picture by pressing the FAR/NEAR
button on the Remote Commander.
You can also clear the still image using the [Clear] item on the
submenu when you are on-line, or by pressing the STILL
IMAGE button on the Remote Commander twice.
Sending Still Pictures Continuously
1
Open the Still Image menu.
2
Select Continuous Send with the joystick on the Remote
Commander, then press the joystick, or press the STILL
IMAGE button.
The moving picture on the monitor screen is frozen, and
the still picture is continuously sent.
3
Set up the angle and zoom if you readjust them.
For details on the angle and zoom settings, see “Adjusting
the Camera Angle and Zoom” on page 57.
To cancel sending still pictures
Select Stop with the joystick on the Remote Commander, then
press the joystick.
Note
The interval that takes to send the next still picture depends on
the transfer rate.
Sending Still Pictures of the Object Camera
1
Open the Still Image menu.
2
Select Send Object with the joystick on the Remote
Commander, then press the joystick, or press the STILL
IMAGE button.
The moving picture of the object camera is frozen, and the
still picture is sent. After the still picture is sent, the
moving picture of the object camera is displayed again.
