Appendix
A-7
Appendix
Inserting Batteries into the Remote Commander
Put the negative end at first.
}
]
]
}
The Remote Commander (supplied) controls most of the meeting
functions.
This section describes how to insert batteries into the Remote Commander.
1
Remove the battery compartment cover.
2
Insert two size AA (LR6) alkaline batteries with correct (+) and (–)
polarity into the battery compartment.
When inserting the batteries, be sure to put the negative end at first.
Caution
Be sure to place the negative (–) end of the battery at first. If you place
the positive (+) end at first, there is a possibility of damaging the
insulated film covering the battery and creating a short circuit.
3
Replace the cover.
Battery life
When the Remote Commander no longer functions properly, it is time to
replace the batteries.
Notes on batteries
To avoid possible damage from battery leakage or corrosion, observe the
following.
• Be sure to insert the batteries in the correct direction.
• Do not mix old and new batteries or different types of batteries.
• Do not attempt to charge dry-cell batteries.
• If you do not intend to use the Remote Commander for a long time,
remove the batteries.
• If a battery leakage occurs, clean the battery compartment and replace all
the batteries.
Summary of Contents for PCS-5100
Page 8: ...Features 8 Features ...
