237
HD Camera Unit Parts Identification
C
h
apt
er
8:
C
a
m
e
ra
U
n
its
d
STANDBY lamp
The orange lamp lights when the system
is set to standby mode using the remote
commander.
Rear
e
SYSTEM SELECT switch
The factory default position is “6”. Do not
change this position, as the other positions
are used only for servicing.
f
HDMI video connector
Supplies the images as a HDMI video
signal or DVI video signal.
g
IR SELECT switch
This switch is used only for servicing.
h
VISCA IN connector
To communicate via RS-232, use this
connector. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
i
VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
j
LAN connector (RJ-45 8-pin)
Used only for servicing.
k
DC 12V connector
Connect the supplied camera cable.
l
Reset switch
This switch is used only for servicing.
Bottom
m
BOTTOM switches
This switch is used only for servicing.
Do not change the factory default position
displayed at the bottom of the unit.
n
Tripod screw hole (1/4-20UNC)
When you use a tripod screw, use this
screw hole to fix it.
o
Mounting screw hole (M3)
Use this hole to secure a bracket, etc.
p
Hook-and-loop pad attachment
points
When using the supplied hook-and-loop
pads, attach them near the specified
points.
The nameplate is located on the bottom.
Note
5
6
7 8 9
0 qa qs
Note
Important
qd
qg
qh
qh
qg
qf
qh
qg
