235
Installing the SRG-120DH HD Camera Unit
C
h
apt
er
8:
C
a
m
e
ra
U
n
its
Installing the
SRG-120DH HD
Camera Unit
Place the camera on a flat surface. If you
have to place the camera on an inclined
surface, make sure that the inclination is less
than ±15 degrees, and take measures to
prevent it from falling.
• Do not grasp the camera head when carrying
the camera.
• Do not turn the camera head by hand. Doing
so may result in a camera malfunction.
Use a screwdriver to tighten the tripod
attachment screw while using the following
as a guide for the amount of protrusion (
4
)
from the attachment surface.
4
= 4.5 – 7 mm
4
= 0.18 – 0.27 inches
Attach the camera using three M3 fixing
screw holes located on the bottom of the
camera. Attach the camera to a fitting with a
flat surface using M3 screws with the
following specifications.
4
= 3 – 8 mm
4
= 1/8 – 11/32 inches
Installing the Camera on a
Desk
Notes
Attaching the Camera to a
Tripod
Installing the Camera Using
the M3 Fixing Screw Holes
Installation of the camera using the tripod
screws and screw holes should not be done
for installation on a ceiling or a shelf, etc., in
a high position.
Caution
M3 screw
