Setting up LAN connection
Selecting LAN for Connection Mode in
Setting mode-dependent parameters
displays the Setup of LAN Connection Mode dialog box.
Hints
The Access Point acts as a bridge w hen LAN is selected for Connection Mode.
Select this mode w hen connecting the Access Point to a DSL modem if your DSL provider does not use PPPoE for connection. Refer
here
for the
procedure.
1.
Click the IP Se tup tab.
This dialog box is for assigning information such as the IP address of the Access Point.
Static IP Address
Check this option if your ISDN router is not DHCP-compliant or the DHCP is not used, then fill in the follow ing fields.
IP Address
Enter the IP address of the Access Point.
Subnet Mask
Enter the subnet mask of the Access Point.
Default Router
Enter the IP address for the default router.
Hints
Refer to the manual that comes w ith your ISDN router for details.
To save the parameters you have entered the Access Point configuration file on the hard disk, click SAVE CONFIG.
The file may be loaded by clicking LOAD on the "Selection of connection mode and setup of common parameters" dialog box. See
Loading
the Access Point configuration
.
2.
Click NEXT.
A screen appears asking you to confirm the mode you have selected.
3.
Click UPLOAD.
The configuration you have made is registered in the Access Point.
Note
If an error message appears, re-enter the correct data.
Page 19
Summary of Contents for PCWA-A100 - Wireless Lan Access Point
Page 11: ...Page 11 ...
