41
Playback
Chapt
er
3
Rec
o
rd
ing and
P
la
y
bac
k
To stop the function
Do one of the following to stop the Clip Continuous Rec
function. (A new clip will be generated the next time you
start recording.)
• Perform a clip operation (lock or delete a clip)
• Make a network or FAM connection
• Eject the disc
• Change the recording format (change the setting of
OPERATIONAL FUNCTION >REC FORMAT in the)
setup menu, or change the setting of AUDIO
CONTROL >REC MODE in the setup menu)
• Power the unit off
To turn the function off
Set OPERATIONAL FUNCTION >CLIP CONT. REC in
the setup menu to “OFF”.
Playback
This section describes playback of video and audio on the
unit.
Before starting playback, make the following settings and
adjustments.
Selection of time data to display:
Select with CNTR SEL
on page P1 of the function menu.
Selection of audio channels to monitor:
Select with
MONI CH and MONI SEL on page P1 of the function
menu.
Volume adjustment of the monitor audio:
Adjust with
the LEVEL knob.
Remote/local setting:
Set the remote control switch. If
you set it to REMOTE, also set the setup menu item
INTERFACE SELECT >REMOTE I/F (“REMOTE”
and the connector used appear on the display).
Disc playback start position
Although this unit uses optical discs, it is designed to offer
the most convenient features of tape playback by VTRs.
One of these is the playback start position, which works in
the same way as tape, as described below.
After playback stop
The unit stops at the position where the STOP button was
pressed.
Press the PLAY button to resume playback at the stop
position.
After recording
The unit stops at the position where recording ended.
To play back a clip, press the PREV button to move to the
start frame of any clip, or press the PREV button with the
PLAY button held down to move to any position.
After disc insertion
The unit stops at the position of the disc when it was most
recently ejected.
Press the PLAY button to resume playback at the most
recent position.
The playback position is saved to the disc when the disc is
ejected, which allows playback to start at that position
whenever it is loaded into any XDCAM player.
This function is not available when the Write Inhibit tab of
the disc is set to the recording disabled position, and when
REC INH on the HOME page of the function menu is set
to “ON”.
The REC INH indicator may light when neither of the
above is true if the format of recorded sections on the disc
is not the same as the recording settings of this unit. In this
case, the playback position can be saved to the disc.
Note
