10
PEGA-CC5
19
Step 2: Setting up your CLIÉ™ handheld for
the car cradle
Follow the setup procedure according to your CLIÉ handheld type.
Removing the protection cover (short screen type)
Before mounting and using your CLIÉ handheld in the car cradle, you need to
remove the protection cover.
Whenever you use your CLIÉ handheld with the car cradle, remove the
protection cover.
b
For details about attaching the cover, refer to the manual supplied with your CLIÉ
handheld.
Changing the operating style (long screen type)
Before mounting, you need to change the operating style.
Set your CLIÉ handheld to the “turned style.”
b
For details about closing the display panel, refer to the manual supplied with your
CLIÉ handheld.
Push
1
with
your left hand.
Remove the cover in
the direction
2
pulling
the other side of
1
.
Open the display and
rotate it as indicated by
the arrow until it clicks into
place.
Fold the display
over the keyboard.
b
b
Continued on next page
xxxxxxxxxxxxxxxxxxxxxxxxxxx
20
Step 3: Mounting your CLIÉ™ handheld in
the car cradle
To operate applications/functions during in-vehicle mode, mount your CLIÉ
handheld in the car cradle.
Notes
• Do not mount or remove your CLIÉ handheld while driving.
• When you operate
Car Setting
, detach your CLIÉ handheld from the car cradle.
During in-vehicle mode,
Car Setting
is not displayed.
• Use the correct holding arm for your CLIÉ handheld screen type.
c
c
1
Mount your CLIÉ handheld on the connector of the car cradle.
Short screen type
Long screen type
21
Note
Do not mount your CLIÉ handheld on the connector of the car cradle vertically.
Detaching your CLIÉ handheld from the car cradle/
turning off the car cradle
The car cradle turns on when your CLIÉ handheld is mounted in the car cradle.
When the car cradle is not in use, detach your CLIÉ handheld from the car
cradle following the instructions below to turn off the car cradle. When you
leave the car, take your CLIÉ handheld with you.
2
Tilt back your CLIÉ handheld to rest in the car cradle.
Continued on next page
xxxxxxxxxxxxxxxxxxxxxxxxxxx
22
Notes
• If battery power is not turned off when the ignition key is in the OFF position, detach
your CLIÉ handheld from the car cradle as battery drain may result.
• Do not detach your CLIÉ handheld from the car cradle with one hand. It may cause a
malfunction.
Charging your CLIÉ handheld
Your CLIÉ handheld battery is continuously being charged during in-vehicle
mode. When the ignition switch is in the OFF position, power from the
cigarette lighter socket terminates is stopped, the car cradle is turned off and
battery charge stops.
Notes
• If your CLIÉ handheld battery is low, you cannot use the CLIÉ handheld in the car
cradle. Be sure to charge the CLIÉ handheld before using with the car cradle.
• If battery power is not turned off when the ignition key is in the OFF position, detach
your CLIÉ handheld from the car cradle. The car cradle will not be turned off when
the ignition key is in the OFF position. Therefore, if your CLIÉ handheld is in the car
cradle, battery drain may result.
Tip
If your CLIÉ handheld is turned off in the car cradle (in-vehicle sleep mode) during
in-vehicle mode, battery charge continues.
1
Squeeze both
RELEASE
buttons simultaneously with one hand.
2
Pull out the CLIÉ handheld towards you from the top with your other
hand.
Summary of Contents for PEGA-CC5
Page 61: ...61 PEGA CC5 MEMO ...
