6
A
B
C
LED
Analog mode switch
LED: Off
SELECT
button
START
button
L1 button
L2 button
R2 button
R1 button
π
button
¢
button
®
button
✕
button
Analog mode switch
Directional button
* Before using the controller, rotate the sticks once
with your thumbs as if drawing a circle, as shown in
the diagram at left. Do not twist the sticks.
SELECT
button
Left stick / L3 button *
START
button
LED: Red
R2 button
Analog mode switch
Directional button
Right stick / R3 button *
L2 button
L1 button
R1 button
* The R3 button and the L3 button function when the stick is pressed.
π
button
¢
button
®
button
✕
button
Analog Controller usage
A
Mode switching and LED
display
This Analog Controller (DUAL SHOCK) can be
switched between two modes by pressing the
analog mode switch.
Each time the analog mode switch is pressed,
the mode changes as follows.
Digital mode (LED : Off)
µ
Analog mode (LED : Red)
Note
After checking the “
” marks
on the software, switch to the appropriate mode for use.
Note however, that some software makes this adjustment
automatically. In such cases, the analog mode switch is
overridden by the software. For details, refer to the
software instruction manual.
B
Digital mode (LED : Off)
You can use this controller in the same manner
as the SCPH-1080 Controller.
C
Analog mode (LED : Red)
Supports software with “
” mark.
Vibration function
This Analog Controller (DUAL SHOCK) is a
touch sensitive controller with a vibration
function. The vibration function can be set to
ON or OFF on the monitor with the software.
The function of each button may vary
depending on the software played. Refer to
individual software instruction manuals for
further details.
Notes
• When the Analog Controller (DUAL SHOCK) is not
used, turn the PlayStation off or unplug the controller
from the “PlayStation”.
• Before using the vibration function of this controller,
please read the following notes on safety.
For safety
• Stop using this unit immediately if you become
tired or if you experience unpleasantness or pain in
your hands or arms while using. If the condition
persists, consult your doctor.
• Do not attempt to operate the controller with
anything other than your hands. Do not operate the
controller with, or attach it to; your head, elbows,
other bony parts of your body, face, or stomach.
• Absolutely do not use the vibration function of the
Analog Controller (DUAL SHOCK) if you have any
ailment in the bones or joints of your hands or
arms.
• Absolutely do not use the vibration function of the
Analog Controller (DUAL SHOCK) when your
fingers, hands, wrists, or arms are broken,
dislocated, or sprained; or if you have a pulled
muscle. These ailments may become worse due to
the vibration of the controller.
• Do not continue to use the Analog Controller
(DUAL SHOCK) for a long time. Take a rest at
about 30 minute intervals.
