7.
Disconnect the three fine-wire coaxial cables from the three connectors CN101, CN201 and CN301 on the HN-399
board.
ハーネス
CN102
CN301
CN101
CN201
HN-399 board
Fine-wire coaxial cable (R)
Fine-wire coaxial cable (G)
Fine-wire coaxial cable (B)
8.
Install the removed parts by reversing steps of removal.
2-14-3. Prism Block Unit
Preparation
1.
Remove the battery lid. (Refer to
2.
Remove the bottom cover. (Refer to
“2-3. Bottom Cover and Tripod Washer”
.)
3.
Remove the inside panel assembly. (Refer to
“2-4-1. Inside Panel Assembly”
.)
4.
Remove the outside panel assembly. (Refer to
“2-5-1. Outside Panel Assembly”
.)
5.
Remove the top panel assembly. (Refer to
6.
Remove the SxS slot assembly. (Refer to
7.
Remove the front panel assembly. (Refer to
8.
Remove the rear panel assembly. (Refer to
.)
9.
Remove the IO-255 assembly. (Refer to
.)
10. Remove the main heat spreader DCP. (Refer to
11. Remove the handle assembly. (Refer to
12. Remove the front lens assembly. (Refer to
.)
13. Remove the HN-399 board. (Refer to
PMW-200/PMW-EX280
2-41
Summary of Contents for PMW-200
