2-16. DPR-355 Board
Preparation
1.
Remove the bottom panel assembly. (Refer to
2.
Remove the inside panel assembly. (Refer to
“2-6-1. Inside Panel Assembly”
)
3.
Remove the outside panel assembly. (Refer to
“2-7-1. Outside Panel Assembly”
)
4.
Remove the rear panel assembly. (Refer to
)
5.
Remove the handle assembly. (Refer to
6.
Remove the IO block. (Refer to
)
7.
Remove the front lens assembly. (Refer to
8.
Remove the DCP-64 board. (Refer to
Procedure
1.
Remove the three screws to detach the USB bracket.
2.
Remove the five screws to detach the heat spreader DPR.
3.
Remove the DPR-355 board from the connector on the AU-357 board.
4.
Disconnect the four fine-wire coaxial cables from the four connectors on the DPR-355 board.
P2 x 4
DPR-355 board
Fine-wire coaxial cables
Fine-wire coaxial cables
Connectors
Connectors
Connector
(AU-357 board)
USB bracket
Hole
Hole
Heat spreader DPR
P2 x 4
P2 x 4
Bosses
Note
When installing the USB bracket, fit the two bosses with the two holes.
5.
Install the removed parts by reversing the steps of removal.
PMW-300
2-48
