2-17. AU-357/RE-320/RE-321/RE-322 Board
Preparation
1.
Remove the bottom panel assembly. (Refer to
2.
Remove the inside panel assembly. (Refer to
“2-6-1. Inside Panel Assembly”
)
3.
Remove the outside panel assembly. (Refer to
“2-7-1. Outside Panel Assembly”
)
4.
Remove the rear panel assembly. (Refer to
)
5.
Remove the handle assembly. (Refer to
6.
Remove the IO block. (Refer to
)
7.
Remove the SxS slot assembly. (Refer to
8.
Remove the front lens assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector on the RE-320 board.
2.
Disconnect the two harnesses from the two connectors on the RE-321 board.
3.
Remove the five screws (P2 x 4).
4.
Remove the AU-357 board from the connector on the DPR-355 board.
Positioning pins
U groove
U groove
P2 x 4
P2 x 4
(a)
(c)
(b)
P2 x 4
Connector
Connectors
AU-357 board
Bracket AU
Connector
(DPR-355 board)
RE-321 board
Harnesses
Harness
RE-320 board
Note
When installing these precision screws, push the U groove of the bracket AU against the positioning pin, and tighten
screws (a) to (c) in alphabetical order.
5.
Remove the screw (P2 x 4).
PMW-300
2-49