2-19. Lens Unit
Preparation
1.
Remove the bottom panel assembly. (Refer to
2.
Remove the inside panel assembly. (Refer to
“2-6-1. Inside Panel Assembly”
)
3.
Remove the outside panel assembly. (Refer to
“2-7-1. Outside Panel Assembly”
)
4.
Remove the rear panel assembly. (Refer to
)
5.
Remove the handle assembly. (Refer to
6.
Remove the IO block. (Refer to
)
7.
Remove the DCP-64 board. (Refer to
8.
Remove the front lens assembly. (Refer to
Procedure
1.
Remove the two screws to detach the front switch panel assembly.
TP2 x 4
Front switch panel assembly
2.
Remove the CMOS harness guide sheet.
3.
Remove the screw (P2 x 4) to detach the front harness cover.
PMW-300
2-53