Sony PMW-F5 Operating Instructions Manual Download

Page: 46 / 134

Useful Functions

Record

ing

• The MLUT setting is locked to “MLUT On” for the

MPEG2 Proxy video that is recorded simultaneously
when in the Cine EI mode.

Recording on the AXS and SxS memory
simultaneously

Set “Setting” in “Rec Control”

(page 85)

of the

Recording menu to “SxS & AXS,” while “Main
Operation” in “Base Setting”

(page 91)

of the

System menu is set to “RAW.”
You can simultaneously record pictures of RAW
format and pictures with formats set by “Rec
Format.”

You can review the last recorded clip on the
screen (Rec Review) by assigning the Rec
Review function to an assignable button

(page

43)

When you stop recording and press the assigned
button, the last 2 seconds of the clip are played.
When you press and hold the button for more than
1 second, the camcorder starts to rewind from two
seconds before of the last frame of the clip at 4×
speed. When you release the button, the
camcorder starts playback at that point.

Rec Review stops at the end of the clip, then
resumes STBY (recording standby) status.

Note

The Setup menus cannot be operated during Rec Review.

By pressing the FOCUS MAG button of the
viewfinder (DVF-L350, DVF-EL100, DVF-
L700) that is attached to the camcorder, you can
expand the center part of the viewfinder, and it is
easy to adjust the focus. After adjusting the focus,
press the button again to returns to the normal
(recording) screen.
It does not affect the recorded image or output
signal in the focus magnifier mode.

You can perform the false color display on the
viewfinder by pressing the SPARE button of the
viewfinder (DVF-EL100, DVF-L700) that is
attached to the camcorder.

For details about the false color display, refer to the
operating instructions of the DVF-EL100 or DVF-
L700.

Note

The false color display is available only when the
“Gamma” setting for the video signal that is output to the
viewfinder is set to “S-Log2.”

If the system frequency is 23.98P, 24P, 25P, or
29.97P, the image may be blurred and hard to see
because of low frame frequency when you shoot
while swaying the camcorder to the right and the
left.
In this case, you can decrease image blur and
make it easier to see by activating the viewfinder
double speed drive function.
To activate, set “Double Speed Drive” in “VF
Setting”

(page 80)

of the VF menu to “On.”

Notes

• This function is not effective on the following settings.

—System frequency is 59.94/50.
—Recording format is SStP SR-SQ 444/SStP SR-

Lite 422/SStP SR-SQ 422, ProRes 4444/ProRes
422 HQ/ProRes 422, DNxHD 220x/DNxHD 145.

—“Setting” in “Slow Shutter” of the Camera menu is

set to “On.”

—“Setting” in “S&Q Motion” of the Camera menu is

set to “On,” and the “Frame Rate” setting is 1 to
60P.

• When this function is effective and “Setting” in “S&Q

Motion” of the Camera menu is set to “Off,” the
electronic shutter function is locked to on, and the
shutter angle is limited to 180 degrees.