Attaching Optional Devices
25
P
repa
ra
ti
ons
Recommended lenses
PMW-F3K supplied lenses (35 mm/50 mm/85
mm)
SCL-PK6/F, SCL-PK6/M (set of 6 lenses, 20
mm/25 mm/35 mm/50 mm/85 mm/135 mm)
SCL-PK3/F, SCL-PK3/M (set of 3 lenses, 20
mm/25 mm/135 mm)
SCL-P11X15
SCL-Z18X140
For details about available lenses for the camcorder,
contact a Sony service representative.
Do not leave the lens facing the sun. Direct
sunlight can enter through the lens, be focused in
the camcorder, and cause fire.
Notes
• Attach/remove a lens while the camcorder is turned
off.
• A lens is a precision part. Do not place the lens directly
with the mount part down. Attach the cover supplied
with the lens.
• The lens interface of the camcorder is set to “Type C,”
to correspond with the lens that is supplied with the
PMW-F3K, SCL-P11X15, and lenses with a Cooke-
type connector. When using a lens with an ARRI-type
connector, set “Lens interface”
in the
Camera menu to “Type A.” Set to “Off” for SCL-PK6,
SCL-PK3, or other lenses. If this setting is not correct,
an alert message appears when the camcorder is turned
on after attaching the lens.
Attaching a PL mount lens
1
Remove the mount cover from the lens
mount by turning the PL mount lever
counterclockwise.
Note
Turn the PL mount lever counterclockwise to the
stopper position.
2
Insert the lens into the lens mount by
matching the concave part of the lens to
the locating pin on the upper right of the
lens mount.
3
Fix the lens by turning the PL mount
lever clockwise while holding the lens.
Note
Do not turn the lens when attaching the PL mount
lens. It may cause damage to the hot shoe pin.
Attaching Optional
Devices
Attaching a Lens
Caution
PL mount
lever
2
3
Summary of Contents for PMW-F5
Page 134: ......
