Setup Menu List
78
Se
tt
ings
Monitor LUT
Setting for the
monitor LUT
Category
LUT
/ Look Profile /
User 3D LUT
Selects the type of Look for Monitor LUT.
LUT: Outputs images using Preset LUT or User LUT.
Look Profile: Outputs images that are suited for the start point
of color grading or images that are close to print quality by
selecting the Look number.
User 3D LUT: Outputs images using User 3D LUT.
Note
When “Color Space” in “Base Setting” of the System menu is
set to “S-Gamut3.Cine/SLog3” or “S-Gamut3/SLog3,” use a
CUBE file created with “Input” set to “S-Gamut3.Cine/S-
Log3,” and when “Color Space” is set to “S-Gamut/SLog2,”
use a CUBE file created with “Input” set to “S-Gamut/SLog-
2.” Note that if you use a CUBE file created mistakenly with a
different setting, the color will not be correct.
LUT Select
P1: 709 (800%)
P2: HG8009G40
P3: HG8009G33
P4: S-Log2
P5: S-Log3
U1
U2
U3
U4
U5
U6
Selects the type of LUT when “Category” in “Monitor LUT”
is set to “LUT.”
709 (800%): Signals, for which the dynamic range is
expanded up to 800%, by using ITU-R709 as a standard.
HG8009G40: Signals, for which the dynamic range is 800%,
white limit is 109%, and use hyper gamma, for which
video output with 18% gray card is 40%.
HG8009G33: Signals, for which the dynamic range is 800%,
white limit is 109%, and use hyper gamma, for which
video output with 18% gray card is 33%.
S-Log2: Log signal with 1300% dynamic range, for which the
post production process should be performed, and
visibility for Video Monitor is considered. (This setting is
available only when “Color Space” in “Base Setting” of
the System menu is set to “S-Gamut/SLog2.” The color
space is set to S-Gamut.)
S-Log3: Log signal with 1300% dynamic range, which is
close to Cineon Log curve, and the characteristics of film.
(This setting is available only when “Color Space” in
“Base Setting” of the System menu is set to
“S-Gamut3.Cine/SLog3” or “S-Gamut3/SLog3.” The
color space is set to S-Gamut3.)
U1 to U6: Any LUT signal that is imported from an SD card.
Look Profile Select
1: LC-709
2: LC-709typeA
3: SLog2-709
4: Cine+709
Selects the type of Look Profile when “Category” in “Monitor
LUT” is set to “Look Profile.”
User 3D LUT Select
User 3D-1
/ User 3D-2 /
User 3D-3 / User 3D-4
Selects the 3D LUT signal that is imported from an SD Card.
SDI (Main) & Internal Rec
MLUT On /
MLUT Off
Selects whether to apply Monitor LUT to the image that is
output from SDI (Main) and recorded on an SxS memory card.
(When “Main Operation” is set to “RGB,” this setting is
locked to “MLUT Off.”)
Video
Menu items
Sub items and setting values Contents
Summary of Contents for PMW-F5
Page 134: ......
