10
EN
Preparing a Power Source (continued)
Notes
• During recording, you will hear the beep through the
earphone. During playback, you will hear the beep
through the earphone and the speaker.
• During FF (CUE) or REW (REVIEW), the
i
lamp may
flash with a beep. Only when the tape does not run
properly, replace the batteries.
• In some cases when the unit is used with rechargeable
batteries, only one BATT/REC lamp will light even
though the batteries have been fully charged.
• After the batteries have been used for a while, the
BATT/REC lamp(s) may flash with the playback
sound when you turn up the volume; however, this
does not mean that you need to replace the batteries.
• The unit will play back normally for a while even after
i
lamp flashes with a beep. However, replace the
batteries as soon as you can. If you do not, a loud
noise may be emitted by the built-in speaker or
subsequent recording will not be done correctly.
• When the tape starts running or at the end of the tape
the
i
lamp may momentarily light with a short beep.
If the lamp goes off, you do not need to replace the
batteries.
