OPERATING VOLTAGE
Before connecting the unit to Ihe power sourcӎ, check that the vollage selhgctor setting is your power supply. If the
aselector must be reset, disconnect the ac power cgrd and turn the selector with a cdin 50 that the arrow mark of the
Selector points to the proper voltafie figure.
voltgge selector is located on the bottom.
IA line frequency change is not necessary since your turntable system is furnished a servo-controlled motor.
For'“~the cgstofiers in the Unitgd Kingdom
V;/ARNING; This apparagus must by earthqd at the germinals in your 3-pin plug as follows:
IMPORTANT: The wires in this mains lead are coloured in accordaniié with followmg code; Eargh (safety earth}
Neuirql
-. Live As the c0l0urs,0f the"'wires in tl?e mains lead of this”‘apparatus may not correspond with zhelfcoloured
markings idenrifyilwg ,the terminals in plug, procyeecl as follgws.
The yykire which is colourecl gre‘en-and-yellow be col-meciecl to the terminal in the plug is marked with the letter E
or by the earth symbol-1: or coloured green Gr The wire which is coloured blue mus; be gonriected terminal which is
marked with the letter N or ‘colgureg black. The wire which is coloured brown must be connected to the terminai
which is marked with the letter L oF'col?)ured red.
PARTS IDENTIFICATION
The picture below Shows the appearance of the assembled
Center Spindle
PITC H Controls
SPEED Selector
Strohgscope
T -
Anti-skating Compensator
Arm Rest
Cueing Lever
Shell
