Checking the version of the PS3™ system software
To use the 3D display, the PS3™ system software must be version 3.70 or later. You
can check the system software version by selecting (Settings)
(System
Settings) [System Information] on the XMB
™
(XrossMediaBar) menu of the
PS3™ system.
Unpacking
ˎ
3D display (1)
ˎ
Stand (1)
ˎ
Neck (1)
ˎ
AC power cord (1)
ˎ
HDMI cable (1)
ˎ
3D glasses (2 sets) (pouch, USB cable)
ˎ
Instruction manual (1)
Assembly
1
Insert the neck into the stand until you hear a click.
Check that the neck and stand face in the same direction, as shown in the
illustration.
2
Securely anchor the neck in place by tightening the mounting screw on the
bottom of the stand.
3
Insert the display into the neck until you hear a click.
Hints
ˎ
Be careful not to pinch your hands or fingers when you assemble
the stand and display.
ˎ
You can adjust the tilt angle of the display by up to 10° from the
vertical (Figure
). Hold the stand down with one hand and move
the upper part of the display with your other hand. Do not try to tilt
the display any further than 10° from the vertical, since this may
damage it.
ˎ
At least two people must perform the steps for removing the display
from the neck and stand. One person must hold the neck and stand
securely on a flat surface and press the button on the hinge. At the
same time, another person can lift the display upwards.
Rear
Press to detach display from neck
and stand.
Using the 3D display
Front
Status indicator
Red: power off (standby mode)
Blue: starting up
Green: running
Orange: no input signal
3D sync transmitter
Infrared receiver
Infrared receiver for the remote control
(sold separately).
