64
When you load an unformatted SxS memory card,
or load an SxS memory card that has been
formatted to other specifications, a message
“Cannot Use Media(A)/Unsupported File
System” appears in the viewfinder. In this case,
format the memory card in the following way.
Note
SxS memory cards not formatted on an XDCAM EX
device cannot be used.
To format (initialize) a memory card
1
Select “OPERATION” > “Format
Media” in the setup menu
.
2
Select “Media(A)” (slot A) or
“Media(B)” (slot B).
3
Turn the MENU knob to select
“Execute,” and then press the knob.
The confirmation message for formatting is
displayed on the viewfinder screen.
4
Turn the MENU knob to select
“Execute” and press the knob.
Execution of the format starts.
During execution, a progress indication appears
(%), and the ACCESS lamp lights in orange.
Recording and playback during format execution
Even during execution of a format, recording and
playback are possible using an SxS memory card
loaded into the other card slot.
If the format operation fails
A format operation may fail because the SxS
memory card is write protected, or because it is
not the type of card specified for use with this
camcorder.
In this case, an error message appears. Follow the
instructions in the error message and exchange
the card for an SxS memory card that can be used
with this camcorder.
Notes
• All data is erased when you format a memory card,
including setup files and all of the recorded video data.
• Use the format function of this camcorder to format
SxS memory cards for use on this camcorder. The
formats of cards formatted on other devices are not
recognized as valid formats, making it necessary to
format them again on this camcorder.
You can check the remaining capacity of the SxS
memory cards loaded in the two slots by checking
the recording media remaining capacity display
in the viewfinder.
The camcorder calculates the remaining
recording time for the media in each slot on the
basis of the current video format (recording bit
rate), and displays it in units of minutes.
You can also check the remaining time in the
BATTERY/MEDIA status screen
Notes
• A
mark appears when a memory card is write
protected.
• The remaining capacity indication for memory cards is
an approximation. When recording to a memory card,
in addition to the video data, some space is reserved for
media management. Accordingly, the actual remaining
capacity may be slightly smaller than indicated.
When to exchange SxS memory cards
• The warning message “Media Near Full”
appears, the WARNING indicator and the REC
indication on the viewfinder screen flash, and
the buzzer sounds when the total remaining
recording time of the two memory cards falls to
five minutes during recording.
Exchange one of the cards for media with
available recording capacity.
• If you continue recording, the message “Media
Full” appears and recording stops when the total
remaining recording time falls to 0.
Note
About up to 600 clips can be recorded on one SxS
memory card.
The display of remaining recording time changes to “0”
and the message “Media Full” appears when the clip
limit is reached.
Formatting (Initializing) SxS
Memory Cards
Checking the Remaining
Recording Time
Summary of Contents for PXW-X320
Page 223: ......
