171
4
Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5
To execute the save, select “Execute,”
and then press the MENU knob.
To cancel the save, select “Cancel,” and
then press the MENU knob.
If you choose to execute the save, the
ACCESS lamp lights (in blue on the right-
side panel and in orange in the card slot
section). A completion message appears and
the ACCESS lamp goes out when the data
has been saved to the SxS memory card.
If saving to a USB flash drive, the ACCESS
lamp does not light up.
If an error message appears
One of the following error messages may appear
during execution of the save, or as soon as you
select “Execute.” In this case, the file is not saved
to the SxS memory card.
To assign names to files
Assigning a name before you save data in an ALL
file can make it easier to distinguish your files.
The following characters can be used in file
names.
Alphanumeric characters (a–z, A–Z, 0–9) and
special characters ( ! # $ % & ' ( ) * + , - . / : ; < =
> ? @ [ \ ] ~)
1
Select “FILE” > “All” > “File ID” in the
setup menu.
2
Turn the MENU knob to select a
character, and then press the MENU
knob.
3
Repeat step
3
.
4
When you have finished entering
characters, press the MENU knob to
move the cursor to “SET,” and then
press the MENU knob.
The specified name is displayed.
When you save the file
, the
data will be saved under this name.
Note
When you load a file from an SxS memory card or USB
flash drive (UDF, exFAT modes), the data saved in the
camcorder’s internal memory is overwritten.
For details about menu operations, see “Basic Setup
Menu Operations” (page 115).
1
Select “FILE” > “All” in the setup
menu.
2
Select “All Load SxS” > “Execute.”
When loading from a USB flash drive (UDF,
exFAT modes), select “All Load USB” >
“Execute.”
3
Press the MENU knob.
An All file list box appears.
File numbers where “No File” is displayed
are empty file numbers.
File numbers with a file name or a date and
time are the number of files that already
contain data.
4
Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5
To execute the load, select “Execute,”
and then press the MENU knob.
To cancel the load, select “Cancel,” and
then press the MENU knob.
If you choose to execute the load, the
ACCESS lamp lights (in blue on the right-
side panel and in orange in the card slot
section). The ACCESS lamp goes out and a
completion message appears when the data
has been loaded from the SxS memory card.
If saving to a USB flash drive, the ACCESS
lamp does not light up.
If an error message appears
One of the following error messages may appear
during execution of the load, or as soon as you
select “Execute.” In this case, the file is not
Error message
Problem
Solution
NG:Cannot Save No recordable
media is
inserted.
Insert
recordable
media.
NG:Media Full
The media is
full.
Use media with
free capacity
remaining.
Loading Settings Data
Summary of Contents for PXW-X320
Page 223: ......
