58
When you set the AUDIO SELECT switch to
AUTO, the input levels of analog audio signals
recorded on each channel are adjusted
automatically. You can also make manual
adjustments.
Note
Even if you set the AUDIO SELECT switch to AUTO,
the input levels of digital audio signals are not adjusted
automatically.
Target audio level for manual audio level
adjustment
Make adjustment using –20 dB as the target level.
If the audio level meter shows a maximum level
of 0 dB, then it indicates that the input audio level
is excessive.
1
To adjust the signal input to the AUDIO
IN CH-1 or CH-2 connector, set the
AUDIO IN CH-1 or CH-2 switch to
REAR.
To adjust both input signals, set both
switches to REAR.
2
Set the AUDIO SELECT switch(es)
corresponding to the channel(s) selected
in step
1
to MANUAL.
3
With the LEVEL control(s) for the
channel(s) selected in step
1
, adjust so
that the audio level meter shows up to
–20 dB for a normal input volume.
Correspondence between recording level
adjustments and audio level controls
You can select which audio level control controls
the audio recording level of the input to each of
the AUDIO IN CH-1/CH-2 connectors on
“MAINTENANCE” > “Audio” in the setup
menu.
Rear1/WRR Level:
Channel 1 recording level
Rear2/WRR Level:
Channel 2 recording level
Note
When you have operation of the LEVEL (CH1/CH2)
knobs and MIC LEVEL control linked together, if the
MIC LEVEL control is set to 0, the audio signals on
channels 1 and 2 cannot be recorded. Check the position
of the MIC LEVEL control before adjusting the LEVEL
(CH1/CH2) knobs.
1
Set either or both of the AUDIO IN
switch(es) to FRONT.
2
Set the AUDIO SELECT switch(es) for
the desired channel(s) selected in step
1
to MANUAL.
3
Turn the MIC LEVEL control, and
adjust so that the audio level meter
shows up to –20 dB for a normal input
volume.
Correspondence between recording level
adjustments and audio level controls
You can select which audio level control controls
the audio recording level of the front microphone
input on “MAINTENANCE” > “Audio” in the
setup menu.
MIC CH1 Level:
Channel 1 recording level
MIC CH2 Level:
Channel 2 recording level
Note
When you have operation of the MIC LEVEL control
and LEVEL (CH1/CH2) knobs linked together, if the
LEVEL (CH1/CH2) controls are set to 0, the audio
signals on channels 1 and 2 cannot be recorded. Check
the position of the LEVEL (CH1/CH2) knobs before
adjusting the MIC LEVEL control.
Adjusting the Audio
Level
Manually Adjusting the Audio
Levels of the Audio Inputs from
the AUDIO IN CH-1/CH-2
Connectors
Manually Adjusting the Audio
Level of the MIC IN Connector
Summary of Contents for PXW-X320
Page 223: ......
