Adjustment procedure
1.
Check that a signal of the specification below is output from the VIDEO OUT connector.
• Condition: Adjust VCO one hour after power-on.
• Specification: 27 MHz (upper limit: +100 Hz, lower limit: -100 Hz)
2.
When the VCO does not meet this specification, change the setting of clock frequency so that the specification is
obtained.
If the specification is obtained, press the MENU button to confirm the setting.
Fan Control Setting
The internal fan of the unit is automatically controlled by detecting the internal temperature. The fan operation can be
confirmed with fan control menu.
• Normal : Mode(default) according to menu setting of [Maintenance]/[Fan Control]
• Max : Drive at maximum rotation speed (forcibly On)
• Min : Drive at fixed low speed rotation
• Off : Stop the fan
Factory Preset
The Factory Preset menu is used to return all settings to the default values. While Factory Preset is in execution, a
message “Factory Preset/Executing” appears. When a message “Factory Preset/Power Off > On” appears after execution
of Factory Preset, turn on the power again.
Password Reset
When the software key in software option is installed, in case input password of this time became missing. All installed
software key password is reset to "0000".
INFORMATION Menu
The Information menu is used to display the information and status of the unit.
Displaying the Serial Number
Selecting Serial Number of the Information menu display the serial number of the unit.
Displaying Internal Temperature
The internal temperature of the unit can be monitored by Imager Temperature and Main Board Temperature of the
Information menu.
• Imager Temperature: Internal temperature of the imager board
• Main Board Temperature: Internal temperature of the DPR-362 board
Executing Log Dump
Executing Log Dump acquires the error log information and saves it to the active, writable media.
Select Log Dump under the INFORMATION menu, and execute it with Execute. The process is complete when “Dump
OK” is displayed as a result. Do not remove the media until this message appears.
PXW-X500
4-14
Summary of Contents for PXW-X500
