background image

RDP-X50iP_4-199-673-14(2)_U2

Owner’s Record

The model number and the serial number are located on the 
bottom.
Record the serial number in the space provided below. Refer to 
them whenever you call upon your Sony dealer regarding this 
product.

Model No. RDP-X50iP

 
Serial No.  _______________________________

For customers in the USA

Please register this product on line at 

http://www.sony.com/productregistration

Proper registration will enable us to send you 

periodic mailings about new products, services, 

and other important announcements. Registering 

your product will also allow us to contact you in 

the unlikely event that the product needs 

adjustment or modification. Thank you.

WARNING

To reduce the risk of fire or electric shock, do not 

expose this apparatus to rain or moisture.

To reduce the risk of fire, do not cover the

 

ventilation of 

the apparatus with newspapers, tablecloths, curtains, etc. 

And do not place lighted candles on the apparatus.
To reduce the risk of fire or electric shock, do not expose 

this apparatus to dripping or splashing, and do not place 

objects filled with liquids, such as vases, on the 

apparatus.
Do not install the appliance in a confined space, such as 

a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or batteries 

installed) to excessive heat such as sunshine, fire or the 

like for a long time.
As the main plug is used to disconnect the unit from the 

mains, connect the unit to an easily accessible AC outlet. 

Should you notice an abnormality in the unit, disconnect 

the main plug from the AC outlet immediately.
The unit is not disconnected from the AC power source 

(mains) as long as it is connected to the wall outlet, even 

if the unit itself has been turned off.
The nameplate and important information concerning 

safety are located on the bottom exterior of main unit 

and on the surface of AC power adaptor.

 

You are cautioned that any changes or modifications not 

expressly approved in this manual could void your 

authority to operate this equipment.

CAUTION

Danger of explosion if battery is incorrectly replaced. 

Replace only with the same type.

NOTE

This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to Part 15 of the 

FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference 

to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following 

measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician 

for help.

WARNING

Replace the battery for the remote commander with a 

Sony CR2025 lithium battery. Use of another battery 

may present a risk of fire or explosion.

Battery may explode if mistreated. Do not recharge, 

disassemble or dispose of in fire.

Dispose of used battery promptly. Keep away from 

children.

Important Safety Instructions

1)  Read these instructions.

2)  Keep these instructions.

3)  Heed all warnings.

4)  Follow all instructions.

5)  Do not use this apparatus near water.

6)  Clean only with dry cloth.

7)  Do not block any ventilation openings. 

Install in accordance with the manufacturer’s instructions.

8)  Do not install near any heat sources such as radiators, 

heat registers, stoves, or other apparatus (including 

amplifiers) that produce heat. 

9)  Do not defeat the safety purpose of the polarized or 

grounding-type plug. A polarized plug has two blades 

with one wider than the other. A grounding type plug has 

two blades and a third grounding prong. The wide blade 

or the third prong are provided for your safety. If the 

provided plug does not fit into your outlet, consult an 

electrician for replacement of the obsolete outlet.

10)  Protect the power cord from being walked on or pinched 

particularly at plugs, convenience receptacles, and the 

point where they exit from the apparatus.

11)  Only use attachments/accessories specified by the 

manufacturer.

12)  Use only with the cart, stand, tripod, bracket, or table 

specified by the manufacturer, or sold with the apparatus. 

When a cart is used, use caution when moving the  

cart/apparatus combination to avoid injury from tip-over.

13)  Unplug this apparatus during lightning storms or when 

unused for long periods of time.

14)  Refer all servicing to qualified service personnel. Servicing 

is required when the apparatus has been damaged in any 

way, such as power-supply cord or plug is damaged, liquid 

has been spilled or objects have fallen into the apparatus, 

the apparatus has been exposed to rain or moisture, does 

not operate normally, or has been dropped.

For the state of california, USA only

Perchlorate Material –special handling may apply, see 

www.dtsc.ca.gov/hazardouswaste/perchlorate  

Perchlorate Material: Lithium battery contains perchlorate

The validity of the CE marking is restricted to only those 

countries where it is legally enforced, mainly in the 

countries EEA (European Economic Area).

Disposal of Old Electrical & Electronic 

Equipment (Applicable in the European 

Union and other European countries 

with separate collection systems)

Features

Compatible with iPod® and iPhone®

MEGA BASS

Audio in function

Wireless remote commander supplied

Precautions

Play the unit on the power source specified in 

“Specifications.”

To disconnect the AC power cord (mains lead), pull it 

out by the plug, not the cord.

Since a strong magnet is used for the speaker, keep 

personal credit cards using magnetic coding or spring-

wound watches away from the unit to prevent possible 

damage from the magnet.

Do not leave the unit in a location near a heat source 

such as a radiator or airduct, or in a place subject to 

direct sunlight, excessive dust, mechanical vibration, or 

shock.

Allow adequate air circulation to prevent internal heat 

build-up. Do not place the unit on a surface (a rug, a 

blanket, etc.) or near materials (a curtain) which might 

block the ventilation holes.

Should any solid object or liquid fall into the unit, 

unplug the unit and have it checked by qualified 

personnel before operating it any further.

To clean the casing, use a soft cloth dampened with a 

mild detergent solution.

If the unit is placed near a CRT-based TV or projector, 

ghosting may occur on its screen. In this case, move the 

unit away.

NOTES ON LITHIUM BATTERY

Wipe the battery with a dry cloth to assure a good 

contact.

Be sure to observe the correct polarity when installing 

the battery.

Do not hold the battery with metallic tweezers, 

otherwise a short-circuit may occur.

If you have any questions or problems concerning your 

unit, please consult your nearest Sony dealer.

Power sources

Preparing a power source

Connect the AC power cord (supplied) to the AC 

power adaptor (supplied).

Connect the AC power adaptor to the 

DC IN 20V

 

jack on the back of this unit firmly and plug it into a 

wall outlet.

AUDIO IN

DC  IN  20V

AC power 

adaptor

AC power 

cord

To wall 

outlet

Note on the AC power adaptor

Use the Sony supplied AC power adaptor only. The polarity of the 

plugs of other manufactures may be different. Failure to use the 

supplied AC power adaptor may cause the unit to malfunction.

Preparing the remote 

commander

Before using the remote commander for the first time, 

remove the insulation film.

To know when to replace the battery

With normal use, the battery (CR2025) should last for 

about 6 months. When the remote commander no longer 

operates the unit, replace the battery with a new one.

with the + side

facing up

Notes

Do not attempt to charge the battery.

If you are not going to use the remote commander for a long time, 

remove the battery to avoid any damage that may be caused by 

leakage and corrosion.


4-199-673-

14

(2)

Personal Audio  

Docking System

©2010 Sony Corporation          

Printed in China

RDP-X50iP

Operating Instructions

Reviews: