72
Recording Settings (Video)
The [Video] setup allows you to adjust the settings
related to recording.
Select
[Video] in the Setup Display. To use
the display, see “Using the Setup Displays” (page
65). The default settings are underlined.
[Disc Record Mode]
Selects one of the following recording modes:
HQ, SP, LP, EP and ULP (in the order of picture
quality).
[DV Input]
Selects the stereo track when recording from a
digital video camera connected to the DV IN jack
on the front panel.
[LINE 3 In]
Selects a method of inputting video signals for the
LINE 3/DECODER jack. The picture will not be
clear if this setting does not match the type of
video input signal.
[Auto Chapter]
Automatically divides a recording (title) into
chapters by inserting chapter markings at a
specified interval. The markings are inserted while
the recording is being made.
b
Note
Depending on the size of the recording being made, the
actual interval may vary from the interval selected in
[Auto Chapter]. When recording in ULP mode, the
interval is set to 10-minutes. The selected interval should
only be used as an approximation to create chapters.
[ Stereo 1 ]
Records original sound at the
time of shooting. Normally
select this when dubbing a DV/
Digital8 format tape.
[ Stereo 2 ]
Records only additional sound
over-dubbed after shooting.
[ Auto ]
The video input signal will
automatically track the video
signal received.
[ Video ]
Inputs composite video
signals.
[ RGB ]
Inputs RGB signals.
[S-Video]
Inputs S-Video signals.
EP
ULP
Disc Record Mode
DV Input
LINE 3 In
HQ
SP
LP
Auto Chapter
[ No
Separation ]
No chapter mark is inserted.
[ 5 minutes ]
Sets the interval to 5 minutes.
[ 10 minutes ]
Sets the interval to 10 minutes.