95
Addi
tion
al
I
nf
o
rm
at
ion
The programme position cannot be changed
from the programme position you are
recording.
,
Set the TV’s input source to “TV.”
Recording does not start immediately after you
press
z
REC.
,
Operate the recorder only after “LOAD,”
“FORMAT,” or “INFOWRITE” disappears
from the front panel display.
Nothing was recorded even though you set the
timer setting correctly.
,
There was a power failure during recording.
,
The recorder’s internal clock stopped due to a
power failure that lasted for more than 1 hour.
Reset the clock (page 83).
,
The channel was disabled after the timer
recording was set. See “Channel Setting” on
page 80.
,
Disconnect the power cord (mains lead) from the
mains, and connect it again.
,
The programme contains copy protection signals
that restrict copying.
,
Other timer setting overlapped the timer setting
(page 45).
,
There is no DVD inside the recorder.
,
There is not enough disc space for the recording.
,
The recorder was in the process of DV Dubbing.
Recording does not stop immediately after you
press
x
REC STOP.
,
It will take a few seconds for the recorder to input
disc data before recording can stop.
Recording does not stop after you press
x
.
,
Open the remote’s cover and press
x
REC
STOP.
Timer recording is not complete or did not start
from the beginning.
,
There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more than
1 hour, reset the clock (page 83).
,
Other timer setting overlapped the timer setting
(page 45).
,
Disc space was not enough.
Contents previously recorded were erased.
,
Data that has been recorded on a DVD with a PC
will be erased from the disc when the disc is
inserted.
,
“Auto Title Erase” in the TOOLS menu (appears
when you press TOOLS while the Timer List
menu is turned on) is set to “On” (page 45).
,
The title was updated and recorded over
(page 39).
Nothing was recorded even though you set the
Synchro-Rec setting correctly.
,
You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Rec standby mode
(page 46).
,
The recorder was not set to the Synchro-
Recording standby mode. Press SYNCHRO
REC to have the recorder stand by for recording.
Make sure the SYNCHRO REC indicator lights
up on the front panel (page 46).
,
The recorder is connected to the TV output jack
of the connected equipment.
Synchro-Recording does not complete.
,
The timer setting for the connected equipment
overlapped the recorder’s timer setting
(page 47).
,
There was a power failure during the recording.
The recorder automatically starts recording
when the satellite receiver is turned on.
,
The Synchro-Rec function was activated. Turn
off the satellite receiver and cancel the Synchro-
Rec function (page 46).
Recording/Timer recording/
Editing
Recording from the equipment
with a timer
,
continued
