96
The clock has stopped.
,
Set the clock again (page 83).
,
The clock stopped due to a power failure that
lasted for more than 1 hour. Reset the clock
(page 83).
The TIMER REC indicator is flashing.
,
The disc does not have enough space.
,
Insert a recordable disc inside the recorder.
The recording mode indication is incorrect.
,
When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
,
After playing titles recorded in SLP and SEP
mode, the recording mode indication may
change depending on the recorded programme.
The clock does not appear in the front panel
display.
,
“Dimmer” in “Options” setup is set to “Power
Save” (page 90).
,
The “Power Save” in “Options” setup was set to
“On,” and the recorder is in standby (page 90).
The remote does not function.
,
Batteries are weak.
,
The remote is too far from the recorder.
,
The remote’s manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 18).
,
Turn on the recorder.
,
The remote is not pointed at the remote sensor on
the recorder.
,
Different command modes are set for the
recorder and remote. Set the same command
mode (page 20). The default command mode
setting for this recorder and the supplied remote
is DVD3.
,
Set the TV/DVD switch to DVD (page 19).
Other Sony equipment responds to the remote.
,
The same command mode is set for both the
equipment and recorder. Set a different
command mode for the recorder (page 20).
The recorder does not operate properly.
,
Restart the recorder. Press down
[
/
1
on the
recorder for more than ten seconds until
“WELCOME” appears in the front panel display.
,
When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
Five numbers or letters are displayed in the
front panel display.
,
The self-diagnosis function was activated (see
the table on page 97).
The disc tray does not open after you press
Z
(open/close).
,
It may take a few seconds for the disc tray to
open after you have recorded or edited a DVD.
This is because the recorder is adding disc data to
the disc.
The disc tray does not open and “TRAY
LOCKED” appears in the front panel display.
,
Contact your Sony dealer or local authorized
Sony service facility.
“RECOVERY” appears in the front panel
display.
,
The recorder’s recovery function was activated
when the recorder was turned on because the
power was turned off or failed during recording.
Leave the recorder on until “RECOVERY”
disappears from the front panel display.
Display
Remote control
Others
