6-3
6-2. Diagnostic Mode
6-2-1. Model Setting
1) Turn of the main power ON.
2) On the screen after exiting all menu screen’s, press the following buttons “ESC”
k
“CHAP”
k
“1” on the service remote controller.
3) Turn of the main power OFF.
4) Turn of the main power ON.
5) Press four digits properly (Refer to page 5 service remote controller.) by using the according to the screen information.
6) Press the following buttons “ESC”
k
“CHAP”
k
“1” on the service remote controller.
7) Disconnect then reconnect the AC power cord of the unit. Be careful not to impart vibration to the unit immediately after the AC power
cord is disconnected.
8) Reset the recorder to all its factory settings.
(Make sure that the recorder is on. Press and hold “
x
” (STOP) key and press “
1
” (STANDBY/ON) key on the front panel.)
The recorder turns off with all settings reset.
9) Turn of the main power ON.
10) Press “ESC” then “DISP” keys by using the service remote controller and then confirm each Model Name.
11) Press “ESC”. (Returns to the original screen)
[Recorder's Model Setting]
Input the number using the remote for Service.
>---
Input No.
Manufacturer
[ 0101
:
]
[ 0201
:
]
[ 0102
:
]
[ 0202
:
]
[ 0103
:
]
[ 0203
:
]
----
VERSION : ----
SYSCON : RELEASE_100
Rev
:1.
******
TUNERCON : 198.000
OK
DRIVE
: DVD-RW DVR-L11X
OK
1.00
OK
PIC SERIAL : -----
HDD INT : -----
DEVICE : -----
FLASH : 64M
REGION : 2
C :
*********
HDCP : -----
