107
Set
tin
gs
a
nd
Adj
u
st
m
e
n
ts
Selects the colour system when recording
from the connected equipment.
This setting is effective only when recording
from an external input.
b
Notes
• When picture noise appears after you change the
“Input Line System” setting, change the “Input
Colour System” setting (page 112). If picture
noise still appears, hold down
x
(stop) on the
recorder, and press INPUT on the recorder.
• When you change the “Input Line System”
setting, the Dubbing List is erased.
Selects whether this recorder is in power
save mode when the power is turned off
(standby).
Select this to run the “Easy Setup”
programme.
Follow the instructions for “Easy Setup”
(page 26) from step 2.
Input Line System
NTSC
Records in NTSC or PAL-60
colour system.
PAL/
SECAM
Records in PAL or SECAM
colour system.
Power Save
Mode 1
Only aerial input signals are
output to the connected TV
when the recorder is in
standby.
Mode 2
No input signals are output
when the recorder is in
standby.
Off
Does not set to power save
mode. Normally, select this
setting.
HELP Setting
On
Displays Help information for
GUI displays.
Off
Does not set to HELP setting
mode.
Easy Setup (Resetting the
Recorder)