26
If the supplied remote interferes with your
other Sony DVD recorder or player, set the
command mode number for this recorder
and the supplied remote to one that differs
from the other Sony DVD recorder or player
after you have completed “Step 6: Easy
Setup.”
The default command mode setting for this
recorder and the supplied remote is “3
(Default setting).”
You can check the current Command Mode
in the front panel display. For details, see
page 123.
You can change programme positions of the
recorder using the number buttons.
Example: for channel 50
Press “5,” “0,” then press ENTER.
z
Hint
If the aerial cables are connected to both DIGITAL
AERIAL IN and ANALOG AERIAL IN jacks,
you can switch between digital broadcasting and
analogue broadcasting using the INPUT button.
Step 6: Easy Setup
Make the basic adjustments by following the
on-screen instructions in “Easy Setup.”
Be careful not to disconnect the cables or
exit the “Easy Setup” function during this
procedure.
1
Turn on the recorder and your TV.
Then switch the input selector on your
TV so that the signal from the
recorder appears on your TV screen.
The “Language” display appears.
• If the “Language” display does not
appear, select “Easy Setup” in the
“Basic” setup from “Initial Setup” in
the System Menu (page 107).
2
Select a language for the on-screen
displays using
<
/
M
/
m
/
,
, and
press ENTER.
The initial settings message appears.
3
Select “Start” using
M
/
m
, and press
ENTER.
Follow the on-screen instructions to
make the following settings.
If you have a Sony DVD player
or more than one Sony DVD
recorder
The default command mode setting for this
recorder and the supplied remote is “3
(Default setting).”
The remote does not function if different
command modes are set for the recorder
and remote. Set the same command mode.
Changing programme
positions of the recorder using
the remote
[
/
1
<
/
M
/
m
/
,
,
ENTER
EXIT/
O
RETURN
TV
[
/
1
