32
US
• Press 20 if you do not want to send signals to the
TV.
3
Press ENT.
The setting is completed after the input
button you pressed in step 1 flashes twice.
4
Repeat steps 1 to 3 to program the
remote.
• An error has occurred when the input button you
pressed in step 1 flashes five times. Perform this
process from step 1 again.
• The two digits entered last are valid.
To cancel programming
Press the input button (TV, BD/DVD, SAT) you
pressed in step 1. For LINE IN, FM and
DMPORT, press AUDIO.
If programming is unsuccessful,
check the following:
• If the input button you pressed in step 1 does
not light up, the batteries are weak. Replace
both batteries.
• If you do not press the following button within
60 seconds during registration, the operation
will become invalid. Perform the process from
step1 again.
• An error has occurred when the input button
you pressed in step 1 flashes five times after
ENT has been pressed in step 3. Perform the
process from step 1 again.
You can program the remote to control non-Sony
components by changing the code. Once the
control signals have been memorized, you can
use those components as part of your unit.
Furthermore, you can also program the remote
for Sony components that the remote is unable to
control. Note that the remote can only control
components that accept infrared wireless control
signals.
You cannot register any component other than a
TV into the TV button of the remote.
1
Press AV POWER while holding down
the input button (TV, BD/DVD, SAT) for
the component you want to operate.
For example, if you are going to operate a
DVD player, press BD/DVD.
The input button you pressed flashes.
2
Check the manufacture code of the
component you want to operate and
press the number button.
Tip
Notes
Programming the remote
for other components
S
L
O
O
T
U
N
E
M
S
N
OI
T
P
O
G
U
ID
E
DIS
P
L
A
Y
E
M
O
H
N
R
U
T
E
R
AV
POWER
Input buttons
(TV, BD/DVD,
SAT)
Number buttons
ENT
Summary of Contents for RHT-S10
Page 53: ......