– 11 –
KV
-B14PD1
RM-883
2-4. PICTURE TUBE REMOVAL
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short curcuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
•
REMOVING PROCEDURES
2
Using a thumb press down then pull up the rubber cap firmly in the direction
indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the anode button, the
anode-cap can be removed by turning up the rubber cap and pulling it up in the
direction of the arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-caps.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
1
Two screws
(BVTP 4
×
16)
3
Two washer head screws
(BVTP 4
×
16)
!
Four tapping
screws (5)
4
Speaker
block (L)
2
Speaker
block (R)
9
Tension spring
#
Degaussing coil
7
C board
5
Anode cap
Cushion
8
Deflection yoke
"
Picture tube
6
A board
a
a
b
b
c
Anode button
