37
GB
To reset a Component Select
button to its original setting
1
While pressing COMMANDER OFF,
press the Component Select button
which you want to reset.
2
While pressing the CHANGE key,
press that Component Select button
again.
The setting for that Component Select
button returns to the factory setting.
3
Press COMMANDER OFF.
Note
If you have programmed some signals on any
of the keys or buttons with the learning
function (page 16) after you reassigned your
component, the two steps above only clears the
“learned” signals. In this case, perform Step 2
again to reset to the original Component Select
button.
To use the Commander after
assigning other components
Press the reassigned Component Select
button. The keys of the new component
are displayed and you can use the
desired component. Note however that
only the original component name is
displayed.
(In this example, the display would be
like the one below.)
Original component
name
Keys for operating
a CD player
Copying the settings of a
Component Select button to
another button
You can copy the entire settings of a
Component Select button to another
Component Select button. The settings of
the component code (page 8) and the
learned functions (page 16) are copied to
a new button.
Note
You cannot copy the settings to a Component
Select button for which any learning function
has been programmed. (“NG” flashes.)
Continued
