58
Selecting a Channel
with a Single Key Press
— Channel Macro Function
You can program the Channel Macro
function of the components of which the
first digit of the four-digit preset
component code number is 3 (STB),
8 (TV) or 9 (CABLE).
And you can program the Channel
Macro function for the macro keys (Label
keys) when the selected component name
is displayed on the Mode Display key in
Step 4, page 59.
If you program the operation of entering
the 1, 2, 3 and ENTER keys for a macro
key (Label key), you can select channel
123 by pressing that single key.
MENU
EXIT
COMMANDER
OFF
MORE
3
2
1
TV
STB
VCR
DVD
CD
AMP
OTHER
TIMER
LIGHT
MUTING
RECALL
CHANNEL
VOLUME
SYSTEM CONTROL
OK
1
8
4
3
5
2
6
COMMANDER
OFF
Transferring Data between
Commanders (continued)
Notes
• If the Commander is not ready for
receiving the data, press the CLEAR key,
then press the RETURN key to clear the
learned signal on all or one of the
Component Select buttons.
• If “NG” appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending Commander
again to send data.
5
Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
Summary of Contents for RM-AV3000
Page 103: ...103 Full Display ...