Unit Settings
21
8
Select “3 LIGHT ON MODE” by
pressing the
V
/
v
button, then
press the OK button.
The following setting screen for
buttons to activate the button
illumination appears. The current
setting is shown inside [ ].
LIGHT ON MODE
LIGHT [ ALL ]
9
Press the
B
/
b
button or the left/
right MULTI-FUNCTION button
to select which buttons activate the
button illumination.
LIGHT
: The button illumination is
activated by pressing the LIGHT
button only.
ALL
: The button illumination is
activated by pressing any buttons on
the Remote Commander except the
VOL +/– and CH +/– .
The setting changes and a beep
sounds each time you press the
button.
Note
In the “ALL” position, if you use the
Remote Commander frequently, battery life
may be shorter. In this case, shorten the
light-off time.
10
Press the OK button or the center
MULTI-FUNCTION button.
The following “SET MODE” screen
appears.
SET MODE
>3 LIGHT ON MODE
4 DISP. OFF TIME
11
Select “6 FADE EFFECT” by
pressing the
V
/
v
button, then
press OK button.
The following setting screen for fade
effect appears. The current setting is
shown inside [ ].
FADE EFFECT
OFF [ ON ]
12
Press the
B
/
b
button or the left/
right MULTI-FUNCTION button
to select the fade effect of the
button illumination.
OFF
: normal button illumination
ON
: fade in/out the button
illumination
The setting changes and a beep
sounds each time you press the
button.
13
Press the OK button or the center
MULTI-FUNCTION button, then
press the EXIT button or the BACK
button.
The Remote Commander returns to
the normal screen.
To return to the previous screen, and
to quit before finishing
Press the BACK button or the EXIT button, and
the previous screen returns.
Press the BACK button or the EXIT button
while the “SET MODE” screen appears, and
the normal screen returns.
