5. Connect this unit to the camera.
Action Cam excluding HDR-AZ1
When [ACPT?] is displayed on the display panel of the camera, press
the ENTER button of the
camera
.
If [ACPT?] is not displayed on the display panel of the camera, restart the camera and try again from
step 3.
HDR-AZ1/Lens-style Camera (QX series)
When you hear the connection confirmation beep, press and hold
the Wi-Fi button of the camera
(Shutter button for the DSC-QX100/QX10) until you hear the connection beep.
If the connection confirmation beep does not sound, restart the camera and try again from step 3.
If the beep is set to OFF, the connection confirmation beep does not sound.
After the connection is established, the LCD screen of the remote control switches to the Live-View
display and the REC/Wi-Fi lamp lights in blue.
Note
Once all steps are completed, this unit and the camera will be automatically connected when you
turn on the power.
The SSID of the camera is displayed on this unit with “DIRECT-” removed.
You cannot copy images recorded in the camera to this unit.
If you cannot connect this unit to the camera via Wi-Fi / if the
connection is not established
If this unit cannot connect to the camera via Wi-Fi, check that the camera is in single connection mode.
If the camera is not in the single mode, change the connection mode and reconnect it.
If the connection to the camera is not completed, the signal traffic may be heavy. In this case, move to
another location and try again.
