1-1
RM-PP1
Section 1
Installation
Power voltage:
AC 100 to 240 V
±
10%
Power frequency:
50 Hz or 60 Hz
Power consumption: 45 W (70 VA)
Rush current:
Power voltage 100 V IN: 15 A
Power voltage 240 V IN: 60 A
n
AC power supply is required a capacity which is commen-
surate with rush current.
If the capacity of the AC power supply is not enough, the
breaker of AC power of a supply side may operate or this
unit may not operate normally.
1-3-2. Recomended Power Cord
This unit does not come with a power cord.
To get a power cord, please contact your local Sony Sales
Office/Service Center.
w
.
Use the approved Power Cord (3-core mains lead)/
Appliance Connector/Plug with earthing-contacts that
conforms to the safety regulations of each country if
applicable.
.
Use the Power Cord (3-core mains lead)/Appliance
Connector/Plug conforming to the proper ratings (Volt-
age, Ampere).
If you have questions on the use of the above Power Cord/
Appliance Connector/Plug, please contact your local Sony
Sales Office/Service Center.
w
.
Never use an injured power cord.
1
Power cord 125 V 10 A (2.4 m):
!
1-557-377-11
2
Plug holder (Brown):
3-613-640-01
1-1. Supplied Accessories
CD-ROM ......................................................................... 1
.
Program Play Box Control Software
.
Operation manual (PDF)
Operation guide ............................................................... 1
Installation manual .......................................................... 1
Screws for rack mounting (B4
x
8) ................................. 10
1-2. Operating Conditions
c
Good air circulation is essential to prevent internal heat build-
up. Place the unit in location with sufficient air circulation.
Do not block the ventilation holes of the cabinet and the
front and rear panels.
Operating temperature: 5
d
C to 40
d
C
Operating humidity:
20% to 90% (non-condensing)
Storage temperature:
_
20
d
C to 60
d
C
Locations to avoid:
.
Areas where the unit will be exposed to direct sunlight
of any other strong lights.
.
Areas near heat sources.
.
Dusty areas or areas subject to vibration.
.
Areas with strong magnetic field.
.
Areas with much electrical noise.
.
Areas with much static electricity.
.
Areas that is impossible to find a specified room for
installation. (Refer to “1-4. Installation Space”.)
c
Fix the unit securely to avoid slipping if the unit is not
operated at horizontal place.
1-3. Power Supply
1-3-1. Voltage and Power Requirements
This unit’s power line has a switching regulator.
c
Be sure to operate the unit within the range of following
power voltage.
AC inlet
2
1
