1-3
RM-PP1
Front
Rear
660 - 830 mm
(26 - 32
3
/
4
inches)
1-5. Rack Mounting
Explains how to mount this unit into a 19-inch standard rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
c
.
Use the specified rack mount rail.
The use of other rail of low strength may drop the unit
and cause the risk of injury.
.
To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
.
Mount the unit into a rack with a steady posture.
m
.
When other equipment with built-in hard disk drive is
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
.
Adjust the temperature inside the rack within the range
of the unit’s operating temperature.
(Refer to Section 1-2.)
.
Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
When the unit is mounted in a rack, the maximum
traveling distance is illustrated below.
1-5. Rack Mounting
Required Parts
Use the specified parts for rack mounting.
The other supplied parts are not used.
.
Rack Mount Rail RMM-30 (Option)
Slide rails with brackets ............................... 2
Screws (B5
x
8) ........................................... 8
Plate nuts ...................................................... 2 (Not used)
Screws (PWH4
x
10) ................................... 2 (Not used)
n
RMM-30 can be used for a rack with a depth of 660 -
830 mm (26 - 32
3
/
4
inches) for 22” rail.
.
Rack Mount Bracket SXA-2U (Option)
Rack angles .................................................. 2
Screws (B4
x
10) ......................................... 4
Screws (RK5
x
20) ...................................... 4
Polyamide washers ....................................... 4
Ornamental washers ..................................... 4
.
Supplied with the RM-PP1
Screws (B4
x
8) ........................................... 8
n
The RM-PP1 contains ten screws, but the two screws of
them are spare.
88
44
581 (Maximum traveling distance)
Distance to the center of the side rail
Height of the unit mounted in a rack
Unit : mm
