27
GB
Advanced Operations
8
Touch
.
9
Touch USE in the pull-down menu.
The commander returns to the operation
mode.
To use the Learning function for the
buttons on the front panel
Use the Learning function for the same named
keys in the operation screen for AMP or TV.
Example: When you use the Learning function
for the MUTING key in the operation screen
for AMP, the MUTING button on the front
panel is also registered with the same code.
To clear the learned code
Perform steps 1 to 4 above, and touch the key
you want to clear the learned code. The
following display appears. Touch CLEAR to
clear the learned code.
To overwrite the learned code
Perform steps 1 to 5 above, and touch the key
you want to overwrite the learned code. The
same display as “To clear the learned code”
appears. Touch OVER WRITE. A mark (
s
)
blinks in the bottom right corner of the key.
Then follow steps 7 to 9.
About 5 cm – 15 cm
5
Point the remote code receiver section
of this commander toward the receiver/
transmitter on the remote control to be
learned.
6
Touch the key on this commander you
want to use the Learning function
(“
N
” for example).
A mark (
s
) blinks in the bottom right
corner of the key. Perform step 7 within 30
seconds after the mark starts blinking.
7
Press the appropriate button on the
remote control to send the remote
control code.
Press the button more than 1 second. When
this commander receives the remote control
code and the learning is successful, the
mark (
s
) in the bottom right corner stops
blinking, and another mark (
x
) appears in
the upper right corner of the key.
continued
Summary of Contents for RM-TP2
Page 41: ...Additional Information 41GB ...
