6
GB
You can change the factory settings of the input
buttons to suit the components in your system.
For example, if you connect a LD player to the
VIDEO2 jacks on the receiver, you can set the
VIDEO2 button on this remote to control the LD
player.
Note, however, that the settings of the TUNER
button cannot be changed.
1
Press USE MODE for more than 2
seconds.
The indicator lights up.
2
Press the input button you want to
change the assignment of.
The indicator turns off once and turns on
again when a valid button is pressed. Only
the first input button that is pressed will be
registered.
Example: Press VIDEO2.
3
Refering to the table below, press the
input button for the category you want.
The indicator turns off when a valid button
is pressed.
Example: Press DVD twice.
4
Press SOURCE.
The new assignment is registered.
The indicator slowly lights up twice, then
goes off.
To cancel
Press USE MODE during any step.
Tip
If the operation is unsuccessful, the indicator flashes
four times and the remote automatically exits the
button assignment mode. In this case, the new
assignment is not registered and the previous setting
remains.
Notes
• If you do not press a button during step 2 through 4
within 60 seconds, the remote automatically exits the
button assignment mode. Start again from step 1.
• In step 3, if you press the same button more than the
possible number of categories that can be selected,
only the last category is registered for the new
assignment.
Valid buttons and the
corresponding categories
To clear all remote button
assignments
Hold down USE MODE, then press
?/1
.
The remote is reset to its factory-setting.
Advanced Remote Operations
Changing button
assignments
Corresponding
categories
Press
VTR-1
VIDEO1 once
VTR-2
VIDEO2 once
VTR-3
VIDEO3 once
VTR-4
VIDEO1 twice
VTR-5
VIDEO2 twice
VTR-6
VIDEO3 twice
DVD player
DVD once
LD player
DVD twice
TV
TV/SAT once
SAT
TV/SAT twice
Tape deck-A
TAPE once
Tape deck-B
TAPE twice
MD deck
MD/DAT once
DAT deck
MD/DAT twice
CD player-1
CD/SACD once
CD player-2
CD/SACD twice
CD player-3
CD/SACD three times
VIDEO CD player
VIDEO1, then CD/SACD
Summary of Contents for RM-US106
Page 9: ......
