23
GB
Controlling the volume
of visual components
connected to an audio
component
The volume control buttons (
2
+/- and
%
) of the Remote Commander are factory
preset to control the volume based on the
assumption that you hear the sound of
your visual components from your TV
speakers, and that you hear sound of your
audio components from the loudspeakers
connected to your amplifier.
The remote control signal transmitted by
pressing the volume control buttons are
factory preset as follows:
Visual component
: Transmits the
signal to control the volume of a TV.
Audio component
: Transmits the
signal to control the volume of an
amplifier.
For example, to control the volume while
using a DVD player, you do not need to
select the TV to control the TV volume.
If an amplifier is connected to visual
components, change the volume control
setting of all the visual components to
control the volume of the amplifier.
1
While pressing the
(light)
button, press the OTHER
button .
“SET MODE” appears as the screen
title.
2
Press the
V/v
buttons to
select “6 UTILITY”, then
press the OK button or the
centre Label select button.
“UTILITY” appears as the screen
title.
Tip
If a number is displayed before the menu,
you can select the menu by pressing the
number button.
3
Press the
V
/
v
buttons to select
“3 AUDIO SETTING”, then
press the OK button or centre
Label select button.
“AUDIO SETTING” appears as the
screen title.
Tip
If a number is displayed before the menu,
you can select the menu by pressing the
number button.
4
Press the
b
button or right
Label select button.
A beep sounds and “AMP” is shown
inside the [ ].
5
Press the
(light) button or
the RETURN button three
times.
The set mode closes, and the Remote
Commander returns to standby for
operating the A/V components.
To reset the settings
Press the
B
button or the left Label select button
in step 4.
