30
Programming a series of
commands to on the Component
Select buttons (continued)
To clear programmed
commands
1
Press and while holding
SET, press and hold for
more than 3 seconds the
Component Select button
you want to clear.
Notes
• You can program a Control Program
function (Component Macro) for a
Component Select button on which
the Power-On function (page 25) has
been programmed. In this case, the
Power-On function is executed when
you press the Component Select
button or when you or select the
another component while the
consecutive Control Program is being
executed.
• If the procedure is interrupted the
procedure at any point for over more
than 20 seconds, the setting mode
ends and the series of commands will
be programmed up to that point. In
this case, clear the program (page 30)
and start again from Step 1 to set the
entire program from the beginning.
You cannot continue programming
once the setting mode ends.
• If a Component Select button has
already “learned” a remote control
signal (page 14), you can program a
Control Program function
(Component Macro), but the function
does will not work until you clear the
“Learned” Function. To clear the
Learning Learned Function, see
“Changing or erasing the function of
a “learned” button” on page 20.
• While you are setting a program, you
can insert a 0.4 second interval to
before the next step is executed by
pressing the same Component Select
button again. For the example above
in the step 2, you can insert a 0.4
second interval between the TV-on
signal and the TV/VIDEO switching
signal at the exercising as the
program is executed by pressing the
buttons TV
t
POWER
t
TV.
Assigning Other
Components to the
Component Select
Buttons
You can assign another
component to any of the
Component Select buttons not
being used.
Once if you set a Component
Select button to a different type of
component, the entered
component‘s code number
becomes effective.
Notes
• To use the original component
setting, set the component code
number again (page 8).
• If you enter a new brand‘s
component code number without
clearing the previous “learned”
functions on that Component Select
button, the “learned” functions
remain effective. Erase the functions
you do not use frequently.
• You can only assign TVs to the TV
Component Select button.
Summary of Contents for RM-VL710
Page 44: ...44 Printed in China ...
