1
RM-VLZ620_U (US) 4-170-639-
12
(1)
Note
If the setting is incomplete, the
SET
indicator
flashes once and the indicators turn off. Start
again from the beginning.
If you enter a manufacturer’s code that is not
listed in the supplied “Manufacturer’s Code
List,” the setting will be canceled.
To operate the device
1
Press the Device Select button for
the device you want to operate.
The Device Select button flashes.
2
Press
POWER
to turn on the
device.
Press any button to control the
device.
See “Table of Preset Functions”
(page 36) for the functions of
buttons for each device.
If the RM-VLZ620 does not seem to be
working
First, try repeating the setup procedure
using another manufacturer’s code (if
listed for your device).
Try setting the code number using the
Search function (page 15).
The remote control signals may be
different for some devices or functions. In
this case, teach the remote control
appropriate signals to the RM-VLZ620
(page 20).
To clear a manufacturer’s
code setting
You can reset the code of any Device
Select button to its factory setting.
1
Press and hold
SET
for more than
3 seconds.
The
SET
indicator lights up.
While keeping
SET
held down,
press .
2
Enter
- 0 - 2
.
The
SET
indicator flashes three
times.
Press the Device Select button
you want to reset.
The
SET
indicator flashes three
times and the indicators turn off.
To cancel the process, press
SET
anytime.
Notes
When you reset a Device Select button, the
learned function or programmed
consecutive procedure will also be cleared
from the button.
To clear all the settings of the RM-VLZ620,
see page 32.
